Owner`s manual

4 – Installation (continued)

4-6 Perpendicular Rack Attachment (4-Post Racks)

Step 1. In order to make perpendicular attachments to a 4-post rack, you will need to utilize two Adjustable J-Hook Clamps. To

makeperpendicularattachmentsbetweentwo4-postracks,youwillneedallfourAdjustableJ-HookClamps.Extendthe

SRCABLELADDER between your two intended racks (or wall). Take one of the Adjustable J-Hook Clamps and insert one of the

J-Hooks into its hole. (It is important that you use the hole with the raised edge to insert your hook. The raised edge accommodates the

edge of the rack’s perpendicular frame.)

Step 2. Wrap the J-Hooks and clamps around the frame of the ladder. The other side of the clamp (without the J-Hook installed) will wrap

underneath the perpendicular frame on the 4-post rack. Tighten this system by securing the J-Hook to the Adjustable J-Hook Clamp

usingtheincludedM8WashersandM8HexNuts.Repeatthisprocedurefortheothersideoftheladderframe,ifmakingattachments

between two 4-post racks.