Owner`s manual

4 – Installation (continued)

4-4 Parallel Rack Attachment (2-Post or 4-Post Racks)

If attaching an SRCABLELADDER in a parallel conﬁguration between two Tripp Lite 2-Post or 4-Post Open Frame Racks, you will need all

fourM8ThreadedJ-HooksandfourM8HexNutsandWashers.Themountingbracketincludedinthiskitforwallmountingshouldalreadybe

installed on both 2- and 4-Post Racks (Tripp Lite brand).

SimplyextendtheSRCABLELADDERbetweenyourtworacksandsecurebothendstothemountingbracketbyhookingallfourJ-Hooks

aroundtheladderframeatbothsidesandintothepre-drilledholesinthebrackets.AttachtheM8WashersandHexNutstotheJ-Hooksas

shown in the diagram. Note: You can also make parallel to perpendicular attachment between racks. See the next section for details.

2-Post Rack

4-Post Rack