Owner`s manual

After measuring for distance and modifying the SRCABLELADDER parts, mount the SRLADDERATTACH wall bracket to a wall or other

appropriate surface with user supplied bolts. The bracket’s pre-drilled holes are .433 inches (11 mm) in diameter and are spaced 18.819 inches

(478 mm)/or 16 inches (406 mm) apart.

Warning: Be sure to mount the bracket in a location able to bear the load.

Note: The SRLADDERATTACH wall bracket can also be attached to Tripp Lite’s 2- and 4-Post Rack Kits. If existing brackets on the 2 or 4 post

kits do not include pre-drilled holes, use the bracket included in your SRLADDERATTACH kit.

4-2 Mounting the Bracket (Wall-Mounting)

4 – Installation (continued)

ExtendtheSRCABLELADDERfromyourrackenclosuretothebracketmountedonthewallandsecureittothebracketbyhookingtwoofthe

J-Hooksaroundtheladderframeandintothepre-drilledholesinthebracket.SecuretheladderbyattachingtwoM8WashersandM8HexNuts

to the J-Hooks as shown in the diagram.

4-3 Attaching the Ladder

18.819 (478 mm)

16 (406 mm)