Owner`s manual

SRCABLELADDER can provide enclosure-to-enclosure cable routing across an aisle or within a single row. You can combine multiple

SRCABLELADDERandSRCABLETRAYaccessoriestomeetthecableroutingneedsofalmostanycongurationofSmartRackEnclosures,

butplanningandmeasurementarerequiredtoensureasecuret.TrippLiterecommendsthatyoureadtheentiremanualinadvancetogaina

clear understanding of the installation process and accessory positioning.

Sample Cable Routing Conﬁguration (Top View)

UseatapemeasuretodeterminethedistancethatSRCABLELADDERwillbridge.(Preassemblingtheladdersectionswillallowyoutoobserve

theirattachmentpointsinplaceforamoreaccuratemeasurement.)

ThestandardlengthofSRCABLELADDERis10feet.Ifthestandardlengthandthedistancebetweenattachmentpointsdiffer,adjustingthe

positionoftheSRCABLETRAYaccessorieswillallowyoutochangethedistancebetweenattachmentpoints.Ifnecessary,youcanuseasingle

laddersectioninsteadoftwosections,reducingtheoverallladderlengthtoapproximately5feet.Inaddition,theassemblybracketsattheends

of the ladder sections will allow minor adjustments if you install them without pins, and you can add a few inches to the length of the ladder

byusingthealternatepinholesforassembly.IftheavailableadjustmentswillnotaccommodatetheSRCABLELADDERaccessory,youmust

cut one of the ladder sections. See Section 3-2 Ladder Modicationforinstructions.IftheSRCABLELADDERaccessorywilltwithout

modication,proceedtoSection 3-3 Ladder Assembly.

Note: Prior to installation, you must install the SRCABLETRAY accessory (sold separately) on each enclosure that will be linked by the

SRCABLELADDER accessory. For ordering information, visit www.tripplite.com.

3-1 Planning

3 – Installation

SRCABLETRAY

SRCABLELADDER installed

between enclosures across an aisle.

SRCABLELADDER installed

between enclosures within a row.

201105211 93-2973.indb 3 5/23/2011 12:56:45 PM