Owner`s manual

9
Enclosure Configuration
Adjusting Mounting Rails and Cable Management Rails
WARNING: Do not attempt to adjust rails without assistance. Do not attempt to adjust rails while equipment is installed in the
enclosure. Do not attempt to use rails without screws installed (6 per rail).
The4mountingrailsarepre-installedtoaccommodateequipmentwithamountingdepthof30inches(762mm).Donotadjustthemountingrails
unlessyourequipmentrequiresadifferentmountingdepth.Thefrontandrearsetsofrailscanbeadjustedindependentlyin¼-inch(6mm)
incrementsformountingdepthsbetween4inches(101.6mm)and42inches(1066.8mm).
3
Lift the panel away from the brace that supports it.
To Reinstall Side Panel, Reverse Steps 1-3
1
 Eachrailisconnectedtotheenclosurewith6screws-1pairattheupperbeam
A
, 1 pair at
the middle beam
B
and 1 pair at the lower beam
C
.
2
 Removethescrewsfasteningeachoftherearmountingrailstotheenclosure.(Ifadjustmentof
thefrontrailsisrequired,youcanalsoremovethescrewsfromthefrontrails.)
3
Slide the mounting rails to the desired depth and reattach them using the screws you removed
in Step 2. The rail attachment points are numbered
A
to help you align each pair of rails at the
same depth.
The depth of the 2 cable management rails can be adjusted using the
same method.
4 5 6 3 4 5 6 7 8 9 0 1 2 3 4 5 6
8
4 5 6 5 6 7 8 9 0 1 2 3 4 5 6 0 1 2 3 4 5 6 7 8 9 0 1 2 3
5
3
1
2
3
A
A
B
C