Owner`s manual

7
Enclosure Configuration
3
Remove the screw and washer from the rear of the door handle and remove the latching
mechanism.Rotatethelatchwashercounter-clockwise90degreesandreversethelatchsoit
pointsintheoppositedirection,thenusethescrewandwashertore-attachthelatchtothe
rear of the door handle.
4
Remove the door by following the steps in the previous section.
5
 Removethedoorhingesfromtheenclosure,rotatethem180degreesandattachthemonthe
opposite side of the enclosure. Note: The alternate door hinge attachment points have plastic
plugs in the screw holes. Remove the plugs and insert them in the original door hinge
attachment points.
6
Unscrew the 2 hinge mechanisms from the hinge openings inside the door, then reattach each
of them using the set of screw holes immediately opposite their original position.
7
 Rotatethedoor180degreesandreinstallitontheenclosure.Remembertoconnectthe
ground wire to the inside of the door, using the attachment point nearest the hinge at the top of
thedoor.Theattachmentpointismarkedwiththegroundconnectionsymbol: .
8
Reinstall the door handle.
3
6
4
7
5
8