Owner`s manual

5
Enclosure Installation
4
 Usethekeytoopentheenclosure'sdoorsandlocatethebaseZone4SeismicBrackets
A
and
reinforcing brackets
B
that are bolted into the shipping pallet. Note: The keys are shipped in
the accessory carton that comes attached to the side panel carton.
5
 Usea13mmopen-endwrenchtoremovetheboltsattachingtheenclosuretotheshipping
pallet.Beextremelycareful,astheenclosurecouldshiftunexpectedlyafterboltremoval.Save
the reinforcing brackets and bracket hardware for later use.
6
 Positionatleastonepersonatthefrontoftheenclosureandonepersonattherearofthe
enclosure. Carefully lift the enclosure from the pallet and place it in the desired location.
WARNING: Use at least one assistant when removing the enclosure from the pallet.
Be extremely careful when moving the enclosure.
Ifrequired,theenclosurecanbeliftedbyattaching4user-suppliedM8diametereyeboltstothe
threadedholesneartheuppercornersoftheenclosureframe.UsesteelboltswithanISOstrength
ratingof8.8orhigher.The4boltscansupporttheweightoftheenclosureandupto1000lb(450
kg)ofinstalledequipment.WARNING: Only experienced equipment operators should
attempt to lift the enclosure. Use appropriate equipment and follow all applicable
safety procedures and regulations.
Placement
Note: Proper anchoring hardware should already be in place before starting this procedure.
1
Use a carpenter’s level to check the slope of the floor in the desired location. If the floor slopes
more than 1%, choose an alternate installation site.
2
 UsingM8hardware(user-supplied),securethebaseoftheenclosureandtheZone4Seismic
Bracketsintopre-installedanchoringhardwareinthefloor.Tightenthehardwareusingatorque
wrench.
Ground Connection
All the parts of the enclosure are grounded to the frame of the enclosure. Connect the frame of the
enclosuredirectlytoyourfacility'searthgroundconnectionusingan8AWG(3.264mm)wireand
one of the pieces of hardware
A
used to secure the enclosure to the floor
. Remove one of pieces
ofhardwaretoconnectthegroundingwireandthenre-fastenthehardwaretosecurethe
connection. WARNING: Attach each enclosure to earth ground separately. Do not use
the enclosure without an earth ground connection.
1
2
4
5
6
FLOOR
EARTH
GROUND
A
B
A