Owner`s manual

8
Enclosure Configuration
Reversing Front Door (continued)
3
Remove the screw and washer from the rear of the door handle and remove the latching mechanism. Rotate
 thelatchwashercounter-clockwise90degreesandreversethelatchsoitpointsintheoppositedirection,
 thenusethescrewandwashertore-attachthelatchtotherearofthedoorhandle.
4
 Removethedoorbyfollowingthestepsintheprevioussection.
5
 Removethedoorhingesfromtheenclosure,rotatethem180degreesandattachthemontheoppositeside
of the enclosure. Note: The alternate door hinge attachment points have plastic plugs in the screw holes.
Remove the plugs and insert them in the original door hinge attachment points.
6
Unscrew the 2 hinge mechanisms from the hinge openings inside the door, then reattach each of them using
the set of screw holes immediately opposite their original position.
7
 Rotatethedoor180degreesandreinstallitontheenclosure.Remembertoconnectthegroundwiretothe
inside of the door, using the attachment point nearest the hinge at the top of the door. The attachment point
 ismarkedwiththegroundconnectionsymbol: .
8
Reinstall the door handle.
3
4
5
7
6
8