Owner`s manual

5
Enclosure Installation
Unpacking (continued)
4
 Usethekeytoopentheenclosure'sdoorsandlocatethe2shippingbrackets
A
that attach the enclosure to
 theshippingpallet.Thebracketsarelocatedinsidetheenclosure.Note: The keys are attached to the front of
the enclosure.
5
 Usea13mmopen-endwrenchtoremovetheshippingbrackets.Beextremelycareful,astheenclosure
 couldshiftunexpectedlyafterbracketremoval.Savethebracketsandbrackethardwareforlateruse.
6
 Positionatleastonepersonatthefrontoftheenclosureandonepersonattherearoftheenclosure.Slowly
 pushtheenclosuretowardthebackoftheshippingpalletuntilallfourcastersgoovertheedgeofthe
pallet and touch the floor. WARNING: Use at least one assistant when removing the enclosure from
the pallet. Be extremely careful when moving the enclosure.
Placement
1
 Usethecasterstomovetheenclosureforashortdistanceoveralevel,smooth,stablesurfacebypushingit
 fromthefrontorrear(notthesidepanels).Donotattempttorolltheenclosureoverlongdistances.The
 enclosureshouldbemovedclosetoitsinstallationlocationinsideitsshippingcontainerbeforeitis
 unpacked.(Useaforkliftorpalletjacktomovetheshippingcontainer.)WARNING: Do not push or pull
the enclosure at the side panels or pull the enclosure toward you.
Ifrequired,theenclosurecanbeliftedbyattaching4user-suppliedM8diametereyeboltstothethreaded
holesneartheuppercornersoftheenclosureframe.UsesteelboltswithanISOstrengthratingof8.8or
higher.The4boltscansupporttheweightoftheenclosureandupto1000lb(450kg)ofinstalled
equipment.WARNING: Only experienced equipment operators should attempt to lift the enclosure.
Use appropriate equipment and follow all applicable safety procedures and regulations.
A
4
5
6
1