200404080 932245 SMARTINT22003000VS OM.qxd 5/26/2004 4:26 PM Page 1 Owner’s Manual Models: SMARTINT2200VS & SMARTINT3000VS Intelligent, Line-Interactive UPS Systems (Tower Configuration) • 230V Input • 2200VA - 3000VA Capacities • Extended-Run Options* * SMARTINT3000VS model Important Safety Instructions 2 Quick Installation 3 Optional Installation 4 Basic Operation 5 Storage & Service 10 Specifications 10 Español 11 Français 22 Póññêèé 33 1111 W.
00404080 932245 SMARTINT22003000VS OM.qxd 5/26/2004 4:26 PM Page 2 Important Safety Instructions SAVE THESE INSTRUCTIONS This manual contains instructions and warnings that should be followed during the installation, operation and storage of all Tripp Lite UPS Systems. UPS Location Warnings • Install your UPS indoors, away from excess moisture or heat, conductive contaminants, dust or direct sunlight. • For best performance, keep the indoor temperature between 32º F and 104º F (0º C and 40º C).
200404080 932245 SMARTINT22003000VS OM.qxd 5/26/2004 4:26 PM Page 3 Quick Installation 1 Insert a user-supplied power cord (with country-specific plug) into the UPS System’s IEC-320-C20 AC Input Receptacle. Plug the cord into an AC wall outlet. NOTE! After you plug the UPS into a live AC outlet, the UPS (in “Standby” mode) will automatically charge its batteries, but will not supply power to its outlets until it is turned ON.
200404080 932245 SMARTINT22003000VS OM.qxd 5/26/2004 4:26 PM Page 4 Optional Installation These connections are optional. Your UPS will function properly without these connections. 1 USB Communications Use the included USB cable to connect the USB port of your computer to the USB port of your UPS. Install on your computer the Tripp Lite PowerAlert Software appropriate to your computer’s operating system.
200404080 932245 SMARTINT22003000VS OM.qxd 5/26/2004 4:26 PM Page 5 Optional Installation 4 EPO Port Connection This optional feature is only for those applications which require connection to a facility’s Emergency Power Off (EPO) circuit. When the UPS is connected to this circuit, it enables emergency shutdown of the UPS's inverter.
200404080 932245 SMARTINT22003000VS OM.qxd Basic Operation 5/26/2004 4:26 PM Page 6 continued “MUTE/TEST” Button • To Silence (or “Mute”) UPS Alarms: briefly press and release the MUTE/TEST button. • To Run a Self-Test: with your UPS plugged in and turned ON, press and hold the MUTE/TEST button for two seconds.* Continue holding the button until the alarm beeps several times and the UPS performs a self test. See “Results of a Self-Test” below.
200404080 932245 SMARTINT22003000VS OM.qxd Basic Operation 5/26/2004 4:26 PM Page 7 continued “VOLTAGE CORRECTION” LED: this green LED lights continuously whenever the UPS is automatically correcting high or low AC voltage on the utility line without the assistance of battery power. The UPS will also emit a slight clicking noise. These are normal, automatic operations of the UPS, no action is required on your part.
200404080 932245 SMARTINT22003000VS OM.qxd Basic Operation 5/26/2004 4:26 PM Page 8 continued Other UPS Features (Back Panel) IEC320-C13 (female) IEC320-C19 (female) AC Output Receptacles: Your UPS features IEC320-C13 AC outlets, and select models also feature IEC320-C19 AC outlets. These output receptacles provide your connected equipment with AC line power during normal operation and battery power during blackouts and brownouts.
200404080 932245 SMARTINT22003000VS OM.qxd Basic Operation 5/26/2004 4:26 PM Page 9 continued Accessory Slot: Remove the small cover panel from this slot to install optional accessories to remotely monitor and control your UPS. Refer to your accessory’s manual for installation instructions. Contact Tripp Lite Customer Support at (773) 869-1234 for more information, including a list of available SNMP, networking management and connectivity products.
200404080 932245 SMARTINT22003000VS OM.qxd 5/26/2004 4:26 PM Page 10 Storage & Service Storage Before storing your UPS, turn it completely OFF: with the UPS ON and receiving utility power, press and hold the ON/OFF/STANDBY button for one second (an alarm will beep once briefly after the interval has passed); then, unplug the UPS from the wall outlet.
11 W. 35th Street, Chicago, IL 60609 USA 773.869.1234 (USA) • 773.869.1212 (International) www.tripplite.
