Owner`s manual

UP
DOWN
A
E
B
C
D
8
Digital Load Meter
1
Select Bank Button:Thisbutton
A
canbepressedtoshowtotalcurrentfor
eachbank.Pressingthisbuttononce
will display the total current for all of the
Bank1outlets,locatednearesttothe
inputcord.TheLEDforBank1
D
will
illuminateandthetotalcurrentforBank
1outletswilldisplayinampsintheLED
Amps display
C
.Pressingthisbutton
A
a second time will produce the same
resultsforBank2.Pressingthebuttona
thirdtimewilldisplaytotalPDUcurrent
andbothBank1andBank2LEDswill
light.Pressingthebuttonadditional
times will repeat the cycle.
 Ifyoupressandholdthisbuttonfor
4seconds,thenumbersintheLED
Amps display
C
will flip for mounting
versatility.Theunitcanbemountedwith
thepowercordfacingthetoporbottom
whilestillbeingabletoreadthedisplay.
2
Select Outlet Button: Thisbutton
B
canbepressedtoshowthecurrentforeach
individualoutlet.TheLEDlocatednexttotheselectedoutletandtheLEDfortheBank
towhichtheoutletbelongs(
D
or
E
)willashwhenthetotalcurrentforthatoutletis
displayed(inamps)ontheLoadMeterDisplay
C
.
Pressingthisbuttonasecondtimewillproducethesameresultsforoutlet2,pressinga
third time for outlet 3 and so on through all the outlets.
 Ifyoupressandholdthisbutton
B
for4secondsyoucandisplaytheIPAddressassigned
totheunitintheLEDAmpsdisplay
C
. The default is no address assigned. If this is the
case,“no address”willdisplay,oneletteratatime.IfthereisanIPAddressprogrammed,
theaddresswilldisplay1digitatatimewithdashes(-)representingdotsorperiods(.).
13-02-027-933161-revB.indb 8 2/7/2013 1:19:16 PM