Owner`s manual

242322212019181716151413
CONFIGACCY
STATUS
LINK
RESET
ENVIROSENSE
121110987654321
5
Installation
Dynamic IP Address Assignment
3-2
Discover IP Address: ContactyournetworkadministratortodeterminewhichdynamicIP
addresshasbeenassignedtothePDUbytheDHCPserver.ThePDUcanbeidentiedon
theDHCPserverbyreferringtoitsMACaddress.(TheMACaddressisa12-digitstringin
thisformat:000667xxxxxx.RefertotheMACaddresslabelattachedtothePDU.)Youmay
wishtorequestalong-termleaseperiodfortheIPaddress,dependingonyourapplication.
AfteryouhavediscoveredtheIPaddress,skipSteps
4-1
through
4-6
and proceed directly
toStep
5-1
.
3-3
Alternate Method:PressandholdtheSelectOutletbuttonontheDigitalLoadMeter
(seepage8)for4secondstodisplaytheIPaddress.Thedefaultisnoaddressassigned.
Ifthisisthecase,“noaddress”willdisplayoneletteratatime.IfthereisanIPAddress
programmed,theaddresswilldisplay1digitatatimewithdashes(-)representingdotsor
periods(.).
Static IP Address Assignment
4-1
Determine IP Information:BeforeassigningastaticIPaddress,you’llneedtoknowthe
IPaddress,gatewayaddressandsubnetmask.Ifyoudonothavethisinformation,contact
yournetworkadministratorforassistance.
4-2
Congure Terminal Emulation Program: OpenaVT100-compatibleterminalemulation
program(suchastheHyperTerminalprogrambundledwithMicrosoft
®
Windows
®
)on
acomputerwithanavailableDB9serialport.(Anotebookcomputermaybethemost
convenientchoice.)SettheterminalemulationprogramtousetheCOMportthat
correspondstothecomputer’sDB9serialport.Specifytheparametersrequiredto
communicatewiththePDUterminalinterface:
 Bitspersecond: 9600  Stopbits: 1
Databits:  8  FlowControl: None
Parity:  None
 Iftheterminalemulationprogramsupportsmultipleemulationmodes,youmayalsoneed
tospecifyVT100emulation.
4-3
Connect PDU to Computer: Use
theRJ-45toDB9congurationcable
(partnumber73-1243)includedwith
thePDUtoconnectthePDUtothe
computer. The connector at one end of
thecableattachestotheCONFIGRJ-45
portonthePDU.TheDB9connectorat
theotherendofthecableconnectsto
the computer’s serial port.
4-4
Press SNMP Reset Button: Usinga
smalltoolorpaperclip,pressthereset
buttonfor3secondstorebootthe
PDU’snetworkcard.Rebootingthe
networkcardwillnoterasenetwork
settings or interrupt AC power.
13-02-027-933161-revB.indb 5 2/7/2013 1:19:14 PM