Owner`s manual

4
Connecting the PDU
2-1
(ModelswithIECpowerinletor3-pole
IEC309plugonly.)Selectmodelshave
adetachablepowercord.Attachthe
includedpowercordtothePDUby
insertingtheIECconnector
A
of the
powercordintotheIECpowerinlet
B
locatedneartheendofthePDU.Use
theincludedbracket
C
to secure the
power cord connection.
Note: Optionally, a user-supplied power cord
can be attached to the PDU by connecting it
to the IEC inlet. Do not attempt to attach a
user-supplied power cord unless it is certified
to be compatible with the input power source
that will be used by the PDU.
2-2
(Optional-modelswithinputplug
adapteronly.)Selectmodelsincludean
input plug adapter that converts the
twist-lockinputplugtoastraight-blade
input plug. Attach the input plug adapter
A
to the input plug
B
if you wish to
plugthePDUintoacompatiblestraight-
bladeoutlet.
2-3
Connecttheinputplugtoacompatible
ACpoweroutlet.IfthePDUdoesnot
haveacircuitbreaker,itshouldbe
providedwithabranch-ratedover-
current protection device that matches
theratedamperageofthePDU.
Note: The AC power source should not share
a circuit with a heavy electrical load.
2-4
(Option1-selectmodelsonly.)Ifyou
attachedthecordretentionbracket(s),
tie each equipment power cord to the
retentionbracket.Attacheachcordto
theretentionshelfbyloopingthecord
and securing it with one of the included
cableties
A
.Makesurethateachcord
canbeunpluggedfromthePDUwithout
removingthecabletie.
  (Option2)UsetheincludedC14and
C20 plastic sleeves to secure plugs to
receptacles. Attach the sleeve to the
plug,makingsurethatthepulltabs
B
remain outside the plug and that the fit
issecure.Tounplugequipmentproperly,
usethepulltabstoremovetheplug
and sleeve from the receptacle.
Installation continued
2-1
2-2
2-3
A
C
B
A
B
2-4
B
A
13-11-194-933093.indb 4 12/5/2013 5:21:56 PM