Owner`s manual

A B
5
2. Features
Accessory Slot: An SNMP card, has been installed in the
slot, allowing the PDU to be monitored remotely.
Factory Port: The port is reserved for conguration by factory
authorized personnel only. Do not connect anything to the
port.
SNMP Card Ports:
PS/2 Port: Use this port to connect a Tripp Lite
ENVIROSENSE environmental sensor to provide remote
temperature/humidity monitoring and a dry contact interface
to control and monitor alarm, security and telecom devices.
Visit www.tripplite.com for ordering information. Note: Do not
connect a keyboard or mouse to this port.
Mini-DIN Serial Port: Use this port to provide a direct
terminal connection to a computer with a terminal emulation
program. A serial cable (part number 73-1025) is included
with the PDU. If you need to order a replacement cable, visit
www.tripplite.com.
Ethernet Port: Use this RJ-45 jack to connect the PDU to the
network with a standard Ethernet patch cable. The Link LED
A
and Status LED
B
indicate several operating conditions, as
shown in the table below. This port is not compatible with PoE
(Power Over Ethernet) applications.
Network Operating Conditions
A
Link LED Color
Off No Network Connection
Flashing Amber 100 Mbps Network Connection
Flashing Green 10 Mbps Network Connection
B
Status LED Color
Off Card Not Initialized
Steady Green Card Initialized and Operational
Flashing Amber Error - Card Not Initialized
201110150-93-3050.indb 5 11/9/2011 11:13:07 AM