Owner`s manual

5
Cord Retention System (PDUMH32HVNET Only)
ToassureasecureconnectionwhenpluggingequipmentintothePDU,usethe
included cord retention system. Follow this procedure for each item of equipment you
connect:
Installation
3-1
Insertacordretentionstrap
A
into
the mounting hole to the right of
thePDUoutlet
B
,pressingfirmly
untilitlocksinplace.IMPORTANT:
when installing the cord retention
strap,ensurethatitsgrooved
surface faces right. The strap will
not function properly if it is
installed with its grooved surface
facing left.
3-2
PlugtheequipmentintothePDU
outlet.
3-3
Slipacordretentionsleeve
C
over
the equipment power cord.
3-4
Slidethecordretentionstrap
through the slot on the cord
retentionsleeve.Pressoutonthe
smalltab
D
at the front of the slot
toinsertthestrap;releaseitto
lockthestrapinplace.
3-5
Lockthecordretentionsleeveover
thepowercordbypressingback
thetabtoengagethelocking
threads.
3-6
Tighten the cord retention strap as
necessary to secure the power
cord against accidental
disconnection.
To disconnect equipment, press out on the slot tab to unlock the cord
retention strap and pull back the cord retention sleeve until it disengages.
3-1
3-2
3-4
3-5
3-3
A
B
Grooved Surface
C
D
201105095 93-3048.indb 5 6/15/2011 3:07:25 PM