Owner`s manual

Features continued
F
Units LEDs:TheAMPS,KWandVOLTLEDsareusedtoillustratetheunitsof
data displayed on the 3-digit display.
Amp LED:Whenselected,theloadisdisplayedinampsonthe3-digitdisplay.
kW LED: Whenselected,theloadisdisplayedinkilowattsonthe3-digitdisplay.
Volt LED:Whenselected,thevoltageisdisplayedonthe3-digitdisplay.
11
6
Output Circuit Breakers: Twocircuitbreakersprotectequipmentconnectedto
eachloadbankagainstoverloads.Ifabreakertrips,thecircuitisoverloadedand
youneedtoreducetheloadconnectedtothecircuitbreaker’sloadbank.Press
thecircuitbreakerbuttontoresetandrestorepower.
7
Ground Connection: Allows you to connect a user-supplied ground wire between
thePDUandanyequipmentthatrequiresachassisground.
8
Cord Retention Bracket (Optional Installation): WheninstalledonthePDU,
cordretentionbracketsprovidesecureattachmentpointsforconnected
equipment power cords.
9
ENVIROSENSE Port (PDUMH30ATNET & PDUMH30HVATNET): Usethisportto
connectaTrippLiteENVIROSENSEenvironmentalsensortoprovideremote
temperature/humidity monitoring and a dry contact interface to control and
monitoralarm,securityandtelecomdevices.Visitwww.tripplite.comforordering
information.Note:Donotconnectakeyboardormousetothisport.
10
Configuration Port (PDUMH30ATNET & PDUMH30HVATNET): Usethisportto
provide a direct terminal connection to a computer with a terminal emulation
program.Aserialcable(partnumber73-1025)isincludedwiththePDU.Ifyou
needtoorderareplacementcable,visitwww.tripplite.com
11
Network Interface (PDUMH30ATNET & PDUMH30HVATNET): UsethisRJ-45
jacktoconnectthePDUtothenetworkwithastandardEthernetpatchcable.
TheLinkLED
A
andStatusLED
B
indicateseveraloperatingconditions,as
shown in the table below. This port is not compatible with PoE (Power Over
Ethernet) applications.
Network Operating Conditions
A
Link LED Color
B
Status LED Color
Off No Network Connection Off Card Not Initialized
Flashing Amber 100 Mbps Network Connection Steady Green Card Initialized and Operational
Flashing Green 10 Mbps Network Connection Flashing Amber Error - Card Not Initialized
13-04-262-93323D-EN.indd 11 5/10/2013 3:02:49 PM