Owner`s manual

Features continued
5
Digital LED Display and
Load Meter (Ammeter)
A
3-Digit Display: Shows
measured or calculated
amperage,kilowattorvoltage
values.
B
Enter Button: Scroll through
DISPLAYandCONFIGURATION
optionsusingthisbutton.While
inDISPLAYmode,ashortpress
switches the display between
AMPS,KWandVOLTS.Whilein
CONFIGURATIONmode,along
press changes configuration
items(TEMPERATURE,AUTO
SCROLL,LEDBRIGHTNESS).
PressingtheEnter button and
Mode button simultaneously
displaystheunit’sIPaddress
(selectmodels).
C
Mode Button: A short press of this button cycles through each of the modes
(PRIMARY,SECONDARY,BANK,TEMP*,HUMIDITY*)ofthepresentcategory
(DISPLAYorCONFIGURATION)forbothprimaryandsecondaryinputs.Along
pressswitchesbetweenDISPLAYandCONFIGURATION.PressingtheMode
button and Enterbuttonsimultaneouslydisplaystheunit’sIPaddress(select
models).
*TEMP/HUMIDITY only available if optional ENVIROSENSE module is attached.
D
Active Input LEDs: Indicate whether the primary or secondary active input is
powering the output.
E
2-Digit Display: Indicates whether the value shown on the 3-digit display
representsprimary,secondary,bank,temperatureorhumidity.
Display Modes:
P: The 3-digit display is showing information related to the primary AC input.
(UnitLEDsdictatewhatdataisshown.)
S: The 3-digit display is showing information related to the secondary AC input.
(UnitLEDsdictatewhatdataisshown.)
b ‘n’:The3-digitdisplayisshowinginformationrelatedtotheoutputbank
number(‘n’).
t ‘n’:The3-digitdisplayisshowingtemperatureforsensor(‘n’).(UnitsforForC
areconfiguredinCONFIGURATIONmode.)
h ‘n’:The3-digitdisplayisshowinghumidityforsensor(‘n’).
ACTIVE INPUT
PRIMARY SECONDARY
AMP
b = BANK
t = TEMP
h = HUMIDITY
P = PRIMARY
S = SECONDARY
VOLT KW
B
D
E
C
F
A
10
13-04-262-93323D-EN.indd 10 5/10/2013 3:02:49 PM