User`s guide

8
3.5.3 Device > Load Groups
The Load Groups menu option will only appear if the device has two (2)
or more controllable loads.
To create a load group click the [+] button on the bottom of the screen
to add a group row to the table. Then, enter a name and description and
click on the Loads cell to expose available loads that can be added to a
group. Click on the select loads and then click the [Save] button on the
bottom of the screen
The description is an editable field. Once changes are made to any, or
all, descriptions, click the [Save] button to save the changes.
To delete a load group, click on the load group row to delete, click the [-]
button and confirm the delete.
3.5.2 Device > Loads
The Loads menu option will only appear if the device supports loads. The
description field is an editable value. In order to save any changes made
on this page, you must click the [Save] button at the bottom of the page.
You can control the outlets of the managed device by selecting the load
and then clicking the appropriate [On], [Off] or [Cycle] button.
The load of connected equipment is displayed in amps, allowing you to
see whether additional equipment can be added safely. (Load fluctuates
with the power demands of connected equipment. It is prudent to
limit the load to approximately 80% of maximum capacity in order to
accommodate higher startup power demands and other increased
power needs.)
If your device has controllable load banks, additional buttons allow you
to control each load bank. (Each load bank consists of one or more
outlets.) You can use the “Description” field to label the banks for easy
reference. The main control buttons affect all outlets at once. Note:
If the control buttons remain grayed out when a load is selected, this
condition indicates the outlet is non-controllable.
3.5 Device Menu continued
3. Web Console continued
Figure 3-10: Loads
Figure 3-11: Load Groups