Installation guide

The OSD functions
2-7
( For the rest of the column downwards to take on the same change press End, End.)
4. Press Esc.
When Timeout activates, the keyboard and mouse are disabled, and a ‘Timeout’ label appears. See Figure 2-6.
Figure 2-6 The TIMEOUT label
To re-enter the system:
Press Esc.
Scanning Computers – F4
You scan computers from the Select Computer window.
To start scanning:
Press F4. During scanning a Confirmation label appears, showing which Remote computer is presently
displayed. See Figure 2-7.
Figure 2-7 The Scan Confirmation label
Note! The scan will skip any active computer set to 000 in the SCN column.
To stop scanning press F4.
Image tuning - F5
You can tune the image of any remote computer screen from the Select Computer window.
To adjust the screen image:
1. Navigate to the remote computer you wish to adjust.
2. Press F5. The screen image of the selected computer appears, together with the Image Tuning IN label.
See Figure 2-8.
Figure 2-8 The Image Tuning IN label
3. Adjust the image by pressing the Right or Left Arrow keys.
4. When the image is satisfactory, press F5 again, the Image Tuning OUT label appears. See Figure 2-9
Figure 2-9 The Image Tuning OUT label
5. Adjust the image by pressing the Right or Left Arrow keys. When the image is satisfactory, press Esc.