IRIPP~U7E POWER PROTEC~ON P I ~ 1111W.35lhStmt Chicago. lL 60609 USA CustomarSupport: (773)8641234 www.trippliia.com - 3 :'A- -. - c I ~pPaM'iE POWER PROTECTION t 1111 W. 35th Street Chicago, IL 60609 USA Customer Support: (773) 869-1234 www.tripplite.com 93-132s (9m3058) 11/99 @u-l.~.rh., ---- . - .-- -- - - - Copynpht 0 199'4 Tnpp Lte All n ~ h t sruervd - a _ _ -- - - .
Advanced, 3-Stage Battery Charger Stage 2 Absorption k ! i. . ""'d CHARGING P OFlLE Automatic Overload Protection Load Sharing (Select models only) If you overload your APS, it will automatically protect itself and your valuable batteries from damage. Select APS models can be set to limit their own charging functions so they can charge their batteries at the quickest rate possible without overloading their power input circuits.
CONFIGURATION DIP SWITCH SETTINGS This manual contains important instructions and warnings that should be followed during the installation, operation and storage of all Tripp Lite APS Systems. DIP SWITCH GROUP A (All models1 BA77ERY TYPE/ VOLTAGE POINT APS Location Warnings -- Install your APS indoors, away from excess moisture or heat, dust or direct sunlight. Leave adequate space around all sides of the APS for proper ventilation.
DIP SWITCH GROUP B (Available on Select Models) LOAiD SHARING/EQUALIZE BATTERY CHARGE Usinglasmall tool, setthemLoadSharing'Configuration DIP Switches, #1 and#2of Group B (located on thc3 front panel of your APS; see Diagram 1, p. 32). DIP Switch #3, Group B should be kept in the '1JP' position when you are not equalizing your batteries' charges. DIP Switch #4, Group B has no function.
Hardwired Electrical Connections (All hardwire models) 1. Connect your APS's positive DC Terminal directly to a fuse. UL recommends that you install a recognized UL component fuse block and fuse within 18 inches of the battery. The fuse's rating must equal or exceed the minimum fuse rating listed in your APS model's specifications on pages 14 or 15. 2 Choose a battery configuration appropriate to your batteries. Single Battery Connection: Refer to Diagram 4, page 33.
