200511135 93-2513 SMART700DV OM.qxd e Y nc NT ION a cha uct! A d RR AT y for pro nty WA ISTRe toda p Litewarra G lin Trip m/ RE r on EE .co te FR lite gis a ipp Re win w.tr to ww 1/12/2006 3:28 PM Page 1 Owner’s Manual SMART700DV Intelligent, Line-Interactive UPS System • 120V/230V Auto-Sensing Input, 120V Output Not suitable for mobile applications.
00511135 93-2513 SMART700DV OM.qxd 1/12/2006 3:28 PM Page 2 Important Safety Instructions SAVE THESE INSTRUCTIONS This manual contains important instructions that should be followed during the installation, operation and storage of all Tripp Lite UPS Systems. Failure to heed these warnings will void your warranty. UPS Location Warnings • The UPS is heavy. Use caution when lifting it. • Install your UPS indoors, away from excess moisture or heat, dust or direct sunlight.
200511135 93-2513 SMART700DV OM.qxd 1/12/2006 3:28 PM Quick Installation 1 Plug the UPS into a wall outlet supplying either 120V or 230V (nominal) AC power. Use the included detachable power cord. The IEC-320 end connects to the AC input receptacle on the rear of the UPS; the NEMA 5-15 end connects to the wall outlet. To plug the UPS into a wall outlet that does not accept a NEMA 5-15 plug, simply replace the included power cord with a detachable cord from another piece of equipment, such as a computer.
200511135 93-2513 SMART700DV OM.qxd 1/12/2006 3:28 PM Page 4 Optional Installation These connections are optional. Your UPS will function properly without these connections. 1 USB and RS-232 Serial Communications Use the included USB cable (see 1a ) and/or DB9 serial cable (see 1b ) to connect the communication port on your equipment to the communication port of your UPS. Install on your equipment the Tripp Lite PowerAlert Software appropriate to your equipment’s operating system.
200511135 93-2513 SMART700DV OM.qxd 1/12/2006 3:28 PM Page 5 Basic Operation Buttons (Front Panel) “ON/OFF/STANDBY” Button • To turn the UPS ON: with the UPS plugged into a live AC wall outlet*, press and hold the “ON/OFF/STANDBY” button for one second.** Release the button. If utility power is absent, you can “cold-start” the UPS (i.e.: turn it ON and supply power for a limited time from its batteries***) by pressing and holding the “ON/OFF/STANDBY” button for one second.
200511135 93-2513 SMART700DV OM.qxd Basic Operation 1/12/2006 3:28 PM Page 6 continued Indicator Lights (Front Panel) All Indicator Light descriptions apply when the UPS is plugged into a wall outlet and turned ON. “POWER” LED: this green LED lights continuously when the UPS is ON and supplying connected equipment with AC power from a utility source.
200511135 93-2513 SMART700DV OM.qxd Basic Operation 1/12/2006 3:28 PM Page 7 continued Other UPS Features (Rear Panel) 15 amp/120V NEMA 5-15R AC Receptacles: Your UPS features 15-amp AC outlets. These output receptacles, provide your connected equipment with AC line power during normal operation and battery power during blackouts and brownouts. The UPS protects equipment connected to these receptacles against damaging surges and line noise.
200511135 93-2513 SMART700DV OM.qxd 1/12/2006 3:28 PM Page 8 Storage and Service Storage Before storing your UPS, turn it completely OFF: with the UPS ON and receiving utility power, press and hold the "ON/OFF/STANDBY" button for one second (an alarm will beep once briefly after the interval has passed); then, unplug the UPS from the wall outlet.
200511135 93-2513 SMART700DV OM.qxd 1/12/2006 3:28 PM Page 9 Battery Replacement Under normal conditions, the original batteries in your UPS will last many years. See Safety section before replacing batteries. The batteries are designed for hot-swap replacement (i.e. leaving the UPS in ON mode), but some qualified service personnel may wish to put the UPS in the OFF mode and disconnect equipment before proceeding.
200511135 93-2513 SMART700DV OM.qxd 1/12/2006 3:28 PM Page 10 Specifications Model: Input Voltage: Input Frequency: Input Receptacle: Output Voltage: Output Frequency: Output Capacity (VA): Output Capacity (Watts): Output Receptacles: Communications Ports: Emergency Power Off (EPO) Port: SMART700DV 120V or 230V AC (nominal), auto-sensing 50 or 60 Hz., auto-sensing IEC-320-C14 (Accepts detachable power cords. Included cord features NEMA 5-15 plug.) 120V AC 50 or 60 Hz.
200511135 93-2513 SMART700DV OM.
200511135 93-2513 SMART700DV OM.qxd 1/12/2006 3:28 PM Page 12 1111 W. 35th Street Chicago, IL 60609 USA Customer Support: (773) 869-1234 • www.tripplite.
