Owner`s manual

11
Enclosure Configuration
Combining (Baying) Enclosures
WARNING: Combining enclosures is not a substitute for stabilizing the enclosures. Each enclosure in a bay of combined enclosures requires the same stabilizing
measures as a standalone enclosure.
1
 Arrangetheenclosuresinthecorrectpositionforbaying.
2
 Eachenclosureincludes4bayingbrackets
A
thatcorrespondtobayingconnectionpoints
B
on the
 adjoiningenclosure.Thebayingconnectionpointsalreadycontainscrews.Removethescrewfromeach
 bayingconnectionpointintheadjoiningenclosure.
3
 Loosenthescrewineachbayingbracketandturneachbracket90degreestowardtheadjoiningenclosure,
 aligningeachbracketwiththecorrespondingbayingconnectionpointontheadjoiningenclosure.
4
 Connecteachbrackettotheadjoiningenclosureusingthescrewsyouremovedinstep2,butdonot
 tightenthescrewscompletely.Adjustthepositionoftheenclosuresasneeded.Ifyouwantthecentersof
 theenclosurestobe24inches(61cm)apart/29.9inches(76cm)fortheSR42UBWD,usetheoutsidehole
 ofthebracket
C
.Ifyouwantthecenterstobe60cm(23.6inches)apart/75cm(29.5inches)forthe
 SR42UBWD,usethemiddleholeofthebracket
D
.Afterconnectingallbracketsandconfirmingthatthe
 enclosuresdonotneedfurtheradjustment,tightenallscrews.
Note: You may wish to remove the doors from the enclosures before combining them. Reinstalling the doors
afterward is optional. Remove the interior side panels before baying enclosures if you wish to enable access
between enclosures.
Equipment Installation
WARNING: Do not install equipment until you have stabilized the enclosure. Install heavier equipment first and install it toward the bottom of the enclosure.
Install equipment starting from the bottom of the enclosure and proceeding toward the top of the enclosure - never the reverse. If using sliding equipment rails,
be careful when extending the rails. Do not extend more than one set of sliding equipment rails at one time. Avoid extending sliding equipment rails near the top
of the enclosure.
Note: The square holes at the middle of each rack unit are numbered and also include a small notch to aid identification. A single rack unit includes the space occupied
by the numbered hole and the holes directly above and below.
90°
24
25
26
27
28
29
23
22
21
20
19
18
24
25
26
27
28
29
23
22
21
20
19
18
24
24
2
1 Rack Unit
3
4
2
1
C
D
A
B
201112001_L 93-2723.indd 11 12/14/2011 11:27:29 AM