Owner`s manual

10
Adding or Removing Side Panels (continued)
3
 Liftthepanelawayfromthebracethatsupportsit.
To Reinstall Side Panel, Reverse Steps 1-3
Enclosure Configuration
Adjusting Mounting Rails and Cable Management Rails
WARNING: Do not attempt to adjust rails without assistance. Do not attempt to adjust rails while equipment is installed in the enclosure. Do not attempt to use
rails without screws installed (6 per rail).
The4mountingrailsarepre-installedtoaccommodateequipmentwithamountingdepthof30inches(762mm).Donotadjustthemountingrailsunlessyourequipment
requiresadifferentmountingdepth.Thefrontandrearsetsofrailscanbeadjustedindependentlyin¼-inch(6mm)incrementsformountingdepthsbetween4inches
(101.6mm)and42inches(1066.8mm).
1
 Eachrailisconnectedtotheenclosurewith6screws-1pairattheupperbeam
A
, 1 pair at the middle
 beam
B
and1pairatthelowerbeam
C
.
2
 Removethescrewsfasteningeachoftherearmountingrailstotheenclosure.(Ifadjustmentofthefront
 railsisrequired,youcanalsoremovethescrewsfromthefrontrails.)
3
Slide the mounting rails to the desired depth and reattach them using the screws you removed in Step 2.
 Therailattachmentpointsarenumbered
A
to help you align each pair of rails at the same depth.
The depth of the 2 cable management rails can be adjusted using the same method.
4 5 6 3 4 5 6 7 8 9
0 1 2 3 4 5 6
8
4 5 6 5 6 7 8 9 0 1 2 3 4 5 6
0 1 2 3 4 5 6 7 8 9 0 1 2 3
5
3
A
B
C
1
2
3
A
201112001_L 93-2723.indd 10 12/14/2011 11:27:26 AM