User Manual

is shown. Pull the trigger to return to the normal operating mode. The

display (smaller digits lower right) will reflect the selected mode.

Backlight – ON/OFF

Press the trigger and release. Use the M button to step to the LitE display.

Press the SET button to select oN or oFF. Pull the trigger to return to the

normal operating mode.

Laser – ON/OFF

Pull the trigger and release. Use the M button to step to the LAS display.

Use the SET button to select oN or oFF. Pull the trigger to return to the

normal operating mode. When the laser is ON, the laser icon will

appear on the LCD.

HIGH Temperature Alarm Limit Setting

Pull the trigger and release. Use the M button to step to Alm H. Use the

arrow buttons to set the High Alarm limit. Press the SET button to turn the

High Alarm OFF. Pull the trigger to return to the normal operating mode. If

the high alarm limit is exceeded when taking measurements, the displayed

ALM H will blink and the alarm buzzer will sound (if ‘bU2’ is set to ON).

LOW Temperature Alarm Limit Setting

Pull the trigger and release. Use the M button to step to Alm L. Use the

arrow buttons to set the Low Alarm limit. Press the SET button to turn the

Low Alarm OFF. Pull the trigger to return to the normal operating mode. If

the low alarm limit is exceeded when taking measurements, the displayed

ALM L will blink.

Emissivity Setting

Pull the trigger and release. Use the M button to step to the icon. Use

the arrow buttons to adjust the emissivity (in 0.01 steps). The emissivity

range is 0.05 to 1.00. Pull the trigger to return to the normal operating

mode. For more information, see the Emissivity section.