User Manual

18 CamView IP Pro Series Combined User Manual
www.Triplett.com
CAMERA SETTINGS:
While you are in the Discover screen, you can press the SET Key to enter the Camera’s
Settings Screen.
The left side of the display shows the Setting’s Class, and the right side shows the details of
the camera’s setting within that class. The classes and details are explained in the table at
the bottom of this page.
Use Zoom +/- to move up or down to select the Class. To select right side items, use the Up
and Down Arrow Keys. Use the Left and RIght Arrow Keys to adjust/change the high-
lighted settings. Use the flip keyboard if you need to type in numbers, letters, or symbols
(e.g., when updating the camera’s IP address to a static IP).
When you have finished, press Iris + to save your changes. The Tester will apply the new
settings to the camera. If the camera accepts the new settings, the “Setup Successful”
prompt will be displayed. Otherwise, failure information will be displayed.
NOTE — Some cameras must be rebooted to apply new settings.
Class Contents
Camera Info Device information including camera model, serial, brand, and other information.
This information cannot be altered.
Scopes Name, location, model number, type(s) of encoder(s) (e.g., video, audio, PTZ),
and the profile of the camera.
eth0 This can be set to Disabled, but is Enabled by default. Includes all the NIC 1
data (e.g., Mac Address, DHCP enabled/disabled, IP address, etc.)
wlan0 This can be set to Enabled, but is Disabled by default. Includes all the NIC 2
data (e.g., Mac Address, DHCP enabled/disabled, IP address, etc.)
Network Includes Hostname, Gateway, DNS, etc.
System This screen details which ports are used for the camera, and whether it is
discoverable.