User Manual

CamView IP Pro Series Combined User Manual 13
www.Triplett.com
OPTION 2
For non-POE IP cameras, the camera can either be powered using its own 12V power adapter or
using the Tester’s 12V/2A power output. When using the Tester’s 12V/2A output, please use the
12V power cable supplied to connect the Tester’s 12V Output Port to the camera’s 12V power
port. You can then connect the ethernet cable from the IP camera to the Tester’s Network Port 2.
(Do not use Network Port 1 in this case as Network Port 1 may try to supply POE and disable the
12V port at the same time. Be sure to use Network Port 2 in this scenario.)
OPTION 3
You can also connect to IP and Wireless IP cameras through a Network Switch. Simply connect
an ethernet cable from the Switch to either the Tester’s Network Port 1 or Network Port 2. The
network status will show on the Tester’s corresponding network port bar and icons after you turn
the Tester on. The Tester supports MDI/MDIX connection.
Option 1 Option 2
Option 3