User Manual

CamView IP Pro Series Combined User Manual 11
www.Triplett.com
• The battery can also be charged using a POE switch or other POE power sources that
meet the 802.3af / 802.3at standard. However, we strongly recommend using the original
POE injector provided with your Tester. DO NOT USE A NON-STANDARD POE POWER
SUPPLY TO CHARGE THE BATTERY—THIS CAN DAMAGE THE TESTER.
3.4 Lanyard
Users can choose to install the lanyard. The lanyard can help when handling the device, prevent
dropping the device, avoid damage to the device, and prevent loss.
To install the lanyard, put one end of the lanyard through the hole at the top of the device, turn
back and go through the slip-lock (i.e., the plastic piece similar to a buckle).Tighten the lanyard
and confirm that it is locked in position.
3.5 Basic Starting Instruction
3.5.1 Turning the Device On and Off
To turn on the device, press and hold the Power Button for more than 2 seconds. The Power
Indicator will light up green when the device is turned on.
To turn off the device, press and hold the Power Button for more than 2 seconds. When the
device is turned off, the green Power Indicator light will turn off after the device is fully shut down.
Users can also setup the idle auto power off feature.
3.5.2 Selecting Function Mode
When the device is on, press the MODE button to switch to the Function Select menu. Press
MODE multiple times or use the Arrow Keys to select a function.
Press the Right Arrow key to enter the selected function.
3.5.3 Using the Flashlight
Press the Power Button twice quickly to turn the Flashlight on/off. You can use the Flashlight
feature even if the tester is off.
The Flashlight will automatically turn off every time the device is turned on or off (to avoid draining
the battery if the Flashlight is turned on accidentally).
WARNING
The LEDs are high brightness LEDs. When the LEDs are on, do not look
directly at them or point them at someone’s eyes as injury may occur.