Use and Care Manual

InfraRed (Non-Contact) Temperature Measurements
1. The IR sensor is located at the top of the meter.
2. Point the sensor toward the surface to be measured.
3. Press and hold the red IR button to begin measuring
the surface temperature of a desired target. IR TEMP
and will appear on the display. The laser pointer
will switch on to help aim the meter.
4. The measured IR surface temperature will appear at
the center of the LCD (larger digits). The temperature
displayed is the temperature of the area within the spot.
5. When the red IR button is released, the laser pointer
will switch off and the reading will freeze (data hold) on
the display for approximately 3 seconds.
6. Note that the vane (Air Temperature) continues to monitor
temperature during IR tests and its temperature is displayed
on the top of the LCD (smaller digits).
7. After approximately 3 seconds the meter
defaults to the Air Flow and Air Temperature
display.
WARNING: Do not directly view or direct the laser pointer at an eye.
Low power visible lasers do not normally present a hazard, but may
present some potential for hazard if viewed directly for extended periods
of time.