User Manual

CCTV TESTER User Manual
3
8
Press more than 2 seconds to turn on or off, short press to turn on or off the menu display
9
Micro SD card removeable, supports up to 32G
10
DC12V 3A power output, temporarily supply power to the camera
11
PoE power supply output/LAN test interface
12
HDMI output
13
Video image /AHD/TVI/CVI signal input（BNC interface）
14
LED lamp
15
DC 12V 1A charging interface
16
RS485 Interface: RS485communication for PTZ control
17
Audio input
18
UTP cable port: UTP cable tester port/ Cable tracer port (Optional)
3. Operation
3.1 Installing the Battery
The tester has
a built-in lithium ion rechargeable battery. The battery should be disconnected for safety during transportation!
Prior to the use of the instrument, please remove the battery insulation paper. Pressing the key to power on /off the tester.
Notice: Please use the original adaptor and connected cable of the device!
When the battery icon is full or the charge indicator turns off, battery charging is completed.
Notice: When the Charge Indicator turns off, the battery is approximately 90% charged. Charging time can be extended for about
1 hour and the charging time under 12 hours will not damage the battery.
Notice: Press the key several seconds to restore the default settings when the instrument works abnormally.
Notice: While Charging, someone must be present.
4. IP camera test
4.1 Power output
Camera can be powered from the DC 12V/3A output or by Power over Ethernet.