User Manual

CCTV TESTER User Manual
15
Test LAN cable or telephone cable.
Connect LAN cable or telephone cable with the CCTV tester and cable tester. And then the connecting status, cable type and the sequence
of wires as well as the serial number of the cable tester kit will be displayed.
The number of the cable tester is 255.
Quickly detect the near-end, mid-end and far-end fault point of RJ45 cable connector
Cable test:
Tap "Diagram of the cable sequence", pop up the connection diagram of Straight-through cable and crossover cable. You can then create a
test report.
6.4 PoE / DC12V 3A power output
When the tester is turned on, the DC12V power output functions are automatically turned on.
To use the PoE Power Output function, change the switch “ON” or “OFF”.
The IP camera needs to connect the LAN port before you turn on PoE Power. If the IP camera supports PoE, the PoE power is delivered via
pins 1, 2, 3, and 6 on the LAN port. The IP tester will display “48V ON” at the top of the screen when the POE power is on.
Note: