User Manual

CCTV TESTER User Manual
13
6.1 Network tool
(1) IP address scan
Connect the cable to the LAN port, click icon to enter, set your IP address search range by changing the Start and End IP addresses.
Click the “Start” button to scan the IP address range. You can also input an IP address in the Port Number Scan to scan for open ports.
(2) PING Test
Application: PING testing is the most conventional network debugging tool. It is used for testing if the connected. IP camera or other
network equipment’s Ethernet port is working normally, and the IP address is correct.
It is normal that the first data packet will be lost when testing starts.
(3) Network test (Ethernet bandwidth test)
To use the Network tester, you will need two IP testers. One is used as a Server and the other as a Client. In order to communicate, both
devices must be on the same network segment.
(4) Port Flashing
Application:
The tester will send special signals to make the connected LAN port flicker at special frequency, which will aid the installer in finding the
connected Ethernet cable easily and quickly. This function can prevent mistakenly inserting or disconnecting the wrong cable and
interrupting network connection.
(5) DHCP server
Click on the DHCP icon to open the DHCP server app. Select the “Start” check box at the top and make any desired changes to the network
settings. Click “Save” to start assigning dynamic IP addresses for IP cameras and other networked devices. Click the “Refresh” button to
check your Client list.