Datasheet

Page 22
Standby and Low Battery:
When the battery is low, the LED (2) won’t light when the power switch
(8) is turned on.
There is a narrow region of battery voltage where the LED will light
up green, but the monitor won’t operate. This can be mistaken for the
Standby mode. To test to see if the monitor is in Standby or the battery
is low, turn the power switch (8) off and back on. If the CVBS box ap-
pears, the monitor was in Standby. It will return to the Standby mode
in a few seconds if a video signal is not applied. If the CVBS box does
not appear, the battery needs to be charged. Refer to Section 7.
If the monitor is in Standby, a video signal applied to the monitor’s
video input will turn it on.
Video and Audio Output:
Video and Audio can be fed out of the monitor and sent to an external
monitor or recording device. Use the supplied cable.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor