TRIPLETT WireMaster HDMI 2 High Definition Cable Tester Instruction Manual 84-893 10 / 2010
WireMaster HDMI FEATURES • Lightweight, Rugged, Simple to use • Test fragile, easily damaged HDMI Patch Cables and In-wall Cables before and after installation • "X-Test" checks for Shorts, Opens, and Miswires in all RGB conductors (most testers only test for Opens) • Tests all HDMI cables with Type A connectors • Verifies conductor used in 1.
them around corners, bending them too sharply, or just rough handling. To meet the requirements of the High Definition Multimedia Interface, some of the wires inside of the cable are very small and easy to damage. Care must be taken during installation to guarantee maximum performance of the cables. The WireMaster HDMI aids the installer by verifying that the cables are good, both before and after the installation.
Installing Battery Remove the Receiver from the bottom of the Transmitter by sliding it downwards (towards the back of the Transmitter). With Receiver removed, remove the Transmitter battery cover by sliding it open. Install a 9 volt alkaline battery taking care to position the lead wires so the battery fits properly in the cavity. Replace the battery cover.
Manual Testing Manual Testing can be helpful in finding an intermittent cable. Set the AUTO/MANUAL button to MANUAL. Set the ON/OFF slide switch to ON while observing the X-Test display. If the Low Battery indicator is lit, replace the battery before continuing. When in the MANUAL mode, the Transmitter will not automatically scan the cable. The user must select the wires to be scanned by pressing the STEP button. Each time the button is pressed, the WireMaster HDMI selects the next wire to be tested.
Product Specifications Cables Tested: HDMI cables with Type A connectors conforming to 1.0, 1.1, 1.2, 1.2a, 1.3, 1.3a, 1.3b, 1.3c, 1.4, 1.4a Category 1 and Category 2 cables Tests Performed: Tests for Opens, Shorts, Miswires Test Modes: Auto or Manual Displays Transmitter: 9 Red LEDs indicate test performed Receiver: 8 Green LEDs, 1 Red / Green LED, indicates test results Battery: Standard 9v Alkaline Battery, ANSI 1604A, IEC 6LR61 Size (approx): Transmitter: 2.8" x 4.8" x 1.1" Receiver: 2.3" x 1.2" x 1.
Triplett One Year Limited Warranty Triplett warrants instruments and test equipment manufactured by it to be free from defective material or workmanship and agrees to repair or replace such products which, under normal use and service, disclose the defect to be the fault of our manufacturing, with no charge within one years of the date of original purchase for parts and labor. If we are undable to repair or replace the product, we will make a refund of the pruchase price.
TRIPLETT Test Equipment & Tools 850 Perimeter Road, Manchester, NH 03103 PHONE: 800-TRIPLETT FAX: 603-622-2960 www.triplett.
