User's Manual

+ Flood Detector installation

1. Open the battery

housing cover

by pulling it

towards the cable,

while holding the

detector body.

2. Remove

the cover and

expose the

battery housing.

3. Install 2 AAA

batteries in the

battery housing,

please note

the polarity

marking.

4. Close the

battery housing

cover.

5. Apply the attached

double-sided adhesive

tape strips to the battery

housing cover in the

placed dened on the

picture.

6. Choose the position and height from the floor level most suitable for

installation, so during flooding detector’s only electrodes would get wet.

Fix both parts of the detector to the wall using the double sided adhesive

tape. The bottom part might be xed using 2 screws (not attached). Ensure

that the box will not be exposed to water. The flood detector contains an

electronic circuit and is not within a watertight casing (the two electrodes

are the only part that should come in contact with water).