User's Manual
82 Document Number: 0100SM1401 Issue: 12-16
Indicated State Alarm
No active alarm
Alarm/s detected
Alarm detection indicator LED (QB & QP only)
The Alarm LED state has two states:
Green: No alarms are currently detected.
Red: An alarm or alarms are currently active. This can be a critical alarm or an
enabled user alarm. See alarms section for further details.
Alarm LED Indications
In some circumstances the radio will indicate an alarm state. This is shown as all LEDs flashing RED for 1 sec and then a pattern of
green LEDs for 1 sec. The pattern of green LEDs indicate the type of alarm. Consult the table for more information.
QR Half Duplex Remote
Alarm Type
COM 1 RxD / TxD COM 2 RxD / TxD Sync / NoRx Pwr / Tx
Supply voltage alarm Green
Retry Factory default Green
Configuration alarm Green Green
Firmware upgrade alarm Green Green
Reverted to factory default due to
internal alarm
Green Green Green
IP address not set (DHCP) Green
Configuration record not found Green Green
Over temperature alarm
(Tx has been disabled)
Green Green Green
Over temperature alarm
(Tx has been folded back)
Green Green Green
VSWR alarm Green Green Green Green
QB / QP
Alarm Type
Pwr / Tx Sync / NoRx COM 1 RxD / TxD COM 2 RxD / TxD
Supply voltage alarm Green
Pairing Alarm (Hot Standby Mode) Green Green
Retry Factory default Green
Configuration alarm Green Green
Firmware upgrade alarm Green Green
Reverted to factory default due to
internal alarm
Green Green Green
IP address not set Green
Configuration record not found Green Green
Over temperature alarm
(Tx has been disabled)
Green Green Green
Over temperature alarm
(Tx folded back)
Green Green Green
VSWR alarm Green Green Green Green