User's Manual

65
Document Number: 0100SM1401 Issue: 12-16
Part F – Quick Reference Guide
Mounting
The QB Full Duplex Radio is housed in a 1RU 19” rack enclosure. The radio is supplied with x2 1RU mounting brackets, which
should be fitted to each side of the radio before it can be installed into a 19” rack. The mounting brackets can be fitted to
the side of the radio in 3 different locations to provide different mounting capabilities: Front Mount, Proud Mount or Center
Mount.
The radio should be mounted in a clean and dry location, protected from water, excessive dust, corrosive fumes, extremes of
temperature and direct sunlight. Allow sufficient passive or active ventilation to allow the radio modem’s heat sink to operate
efficiently.
Antenna connections, Power connections and Digital I/O are all made at the rear of the unit.
All User ports, including; Serial Com ports, Ethernet ports, and Aux port are located on the front panel to provide easy access.
Front Mount
Fixing the mounting brackets for a front mount,
allows the front of the radio to be flush with the
front of a 19” rack.
Proud Mount
Fixing the mounting brackets for a proud
mount, allows the front of the radio to slightly
hang over the front of a 19” rack.
Center Mount
Fixing the mounting brackets for a center
mount, allows the radio to be mounted into a
19” rack which contains a center pillars.