User's Manual

2 Document Number: 0100SM1401 Issue: 12-16
Part G– Quick Start Guide 91
Step-by-Step Point to Point Setup 91
QH Hot Standby Quick Start Guide 95
Step-by-Step eDiags Setup 98
System Topology Configuration 99
Router Mode 104
Network Address Translation (NAT) 108
Virtual LAN (VLAN) 111
Serial and MODBUS 115
Single Frequency (Simplex) Mode 120
E-Series Emulation Mode 122
Part H – Advanced 124
Connectivity 124
Ease of Use 132
Security 155
Part I – Installation & Commissioning 158
Optimising the Antenna for Rx Signal 160
Commissioning 161
Part J – Firmware Updating and Maintenance 162
Firmware Updating 162
Global Firmware Updating 164
Fuse Replacement - QR 171
Part K – Open Source License Acknowledgements 172
Part L – Support Options 173
Contents
Part A – Preface 3
Safety Information 3
Revision History 6
Important Information 6
Compliance Information 7
Part B – Feature Overview 8
Introduction 8
Features and Benefits 9
Q Data Radio Range 10
Part C – System Topologies & Operating Modes 12
System Topologies 12
Operating Modes 17
Part D – Feature Detail 19
Hardware 19
Efficiency and Bandwidth 21
Connectivity 32
Ease of Use 35
Security 42
Part E – Radio Planning and Design 44
Radio Path analysis 44
BER & Fade Margin 46
Radio Accessories 47
Part F – Quick Reference Guide 50
Introduction 50
Half Duplex Radio - QR150 50
Half Duplex Radio - QR450 57
Full Duplex Radio - QB 64
Hot Standby Half Duplex Radio - QP 69
Hot Standby Full Duplex Radio - QH 74
LED indicators 81
Connecting Antennas 84
Communication Ports 84
Activating Transmitter 86
Factory Default 86
Digital I/O 87
Connecting to Web User Interface (WUI) 89
Resolving Ethernet Connection Issues 90