User's Manual

122 Document Number: 0100SM1401 Issue: 12-16
E-Series Emulation Mode
Part G – Quick Start Guide
Introduction
As of firmware release 1.3.6.3674, the Q (UHF only) supports E-Series emulation mode. The Diagram below shows a
typical E-Series PTMP via Repeater topology, where the remote sites have been replaced with half duplex Q data radios.
Configuration values which are fundamental to a successful radio link are shown below to provide an example on how to
configure the Q data radios in E-Series emulation mode. Single frequency or two frequency systems can utilise E-Series
emulation mode.
Modulation: 9600 12.5KHz
Radio Type: Remote
Collision Avoidance: Digital
Ethernet SID: 250
Serial Rx SID: 2
Serial Tx SID: 3
Modulation: 9600 12.5KHz
Radio Type: Access Point
Collision Avoidance: Digital Master
Peer to Peer: Enabled
SID Repeat Range: 2-3
Modulation: E-Series Emulation Mode
Type: 9600 12.5KHz
Radio Type: Remote
Collision Avoidance: Digital
Ethernet SID: 250
Serial Rx SID: 3
Serial Tx SID: 2
Configuration
The configuration parameters shown in the diagram above can be accessed within the Q data radio within the following locations:
Modulation (Setup -> Radio -> Modulation) provides the compatibility options of: Q Data Radio Mode or E/M Data Radio Mode.
Radio Type (Setup -> Radio -> System Parameters) provides the options of:
- Access Point
- Remote