User's Manual

109
Document Number: 0100SM1401 Issue: 12-16
NAT - Point to Multipoint - Full Duplex Entry Point
Host Application
IP: 192.168.0.2/24
Gateway: 192.168.0.1
Remote A
Network Settings:
IP: 192.168.1.1/24
Router Settings:
WAN IP: 10.10.10.2/24
Route Table Entries:
192.168.0.0/24 10.10.10.1
Port Forwarding Rules
Enabled All 2300 192.168.1.2 23
Ethernet Device
IP: 192.168.1.2/24
Gateway: 192.168.1.1
Ethernet Device
IP: 192.168.1.2/24
Gateway: 192.168.1.1
The diagram above provides an example of how to port-forward a Telnet session. In order to establish a Telnet session
from the host application, to the Ethernet device connected to Remote A, the host application will have to use the following
addressing: [Telnet 10.10.10.2 2300]. This address references Remote A’s WAN IP and the unique port number allocated to
the Ethernet device specified within the port forwarding rule.
Entry Point
Network Settings:
IP: 192.168.0.1/24
Router Settings:
WAN IP: 10.10.10.1/24
NAT
Disabled
Part G – Quick Start Guide
Remote B
Network Settings:
IP: 192.168.1.1/24
Router Settings:
WAN IP: 10.10.10.3/24
Route Table Entries:
192.168.0.0/24 10.10.10.1
Port Forwarding Rules
Enabled All 2300 192.168.1.2 23