User's Manual

107
Document Number: 0100SM1401 Issue: 12-16
IP Routing - Serial Data PTMP via multiple Repeaters
Full Duplex Repeater
Network Settings:
IP: 192.168.2.1/24
Router Settings:
WAN IP: 10.10.10.2/24
Route Table Entries:
224.240.1.1 WAN WAN
192.168.1.0/24 10.10.10.1
Remote A
Network Settings:
IP: 192.168.3.1/24
Router Settings:
WAN IP: 10.10.10.3/24
Route Table Entries:
192.168.1.0/24 10.10.10.2
Serial Device
Half Duplex Repeater
Network Settings:
IP: 192.168.4.1/24
Router Settings:
WAN IP: 10.10.10.4/24
Route Table Entries:
224.240.1.1 WAN WAN
192.168.1.0/24 10.10.10.2
Remote B
Network Settings:
IP: 192.168.5.1/24
Router Settings:
WAN IP: 10.10.10.5/24
Route Table Entries:
192.168.1.0/24 10.10.10.4
Remote A, Half Duplex Repeater &
Remote B (Common)
COM1:
Mode: Serial Device Server
Character Layer: 9600,8,N,1
Interface: RS232.
Packet Layer: MODBUS
Protocol: UDP
Protocol Mode: Point to Multipoint
Node Type: Multi-Point
Remote IP Address: 192.168.1.1
Remote IP Port: 30010
Local Multicast IP: 224.240.1.1
Local IP Port: 30010
Host Application
Serial Data
Half Duplex Entry Point
Network Settings:
IP Address: 192.168.1.1/24
Router Settings:
WAN IP Address: 10.10.10.1/24
Route Table Entries:
224.240.1.1 LAN WAN
COM1:
Mode: Serial Device Server
Protocol: UDP
Protocol Mode: Point to Multipoint
Node Type: Point
Remote Multicast IP: 224.240.1.1
Remote IP Port: 30010
Local IP Port: 30010
Serial Device
Serial Device
This topology should use Carrier detect collision avoidance.