User's Manual
Table Of Contents
- Part A – Preface
- Safety Information
- Revision History
- Important Information
- Compliance Information
- Part B – Feature Overview
- Introduction
- Features and Benefits
- Q Data Radio Range
- Part C – System Topologies & Operating Modes
- System Topologies
- Operating Modes
- Part D – Feature Detail
- Hardware
- Efficiency and Bandwidth
- Connectivity
- Ease of Use
- Security
- Part E – Radio Planning and Design
- Radio Path analysis
- BER & Fade Margin
- Radio Accessories
- RF Feeders and Protection
- Part F – Quick Reference Guide
- Introduction
- Half Duplex Radio - QR450
- Full Duplex Radio - QB450
- Hot Standby Half Duplex Radio - QP450
- Hot Standby Full Duplex Radio - QH450
- LED indicators
- Connecting Antennas
- Communication Ports
- Activating Transmitter
- Factory Default
- Digital I/O
- Connecting to Web User Interface (WUI)
- Resolving Ethernet Connection Issues
- Part G– Quick Start Guide
- Step-by-Step Point to Point Setup
- Step-by-Step eDiags Setup
- System Topology Configuration
- Serial and MODBUS
- Single Frequency (Simplex) Mode
- E-Series Emulation Mode
- Part H – Advanced
- Connectivity
- Ease of Use
- Security
- Part I – Installation & Commissioning
- Optimising the Antenna for Rx Signal
- Commissioning
- Part J – Firmware Updating and Maintenance
- Firmware Updating
- Global Firmware Updating
- Fuse Replacement - QR450
- Part K – Open Source License Acknowledgements
- Part L – Support Options
95
Document Number: 0100SM1401 Issue: 05-15
E-Series Emulation Mode
Part G – Quick Start Guide
Introduction
The Diagram below shows a typical E-Series PTMP via Repeater topology, where the remote sites have been replaced with
half duplex Q data radios. Configuration values which are fundamental to a successful radio link are shown below to provide
an example on how to configure the Q data radios in E-Series emulation mode. Single frequency or two frequency systems
can utilise E-Series emulation mode.
Modulation: 9600 12.5KHz
Radio Type: Remote
Collision Avoidance: Digital
Ethernet SID: 250
Serial Rx SID: 2
Serial Tx SID: 3
Modulation: 9600 12.5KHz
Radio Type: Access Point
Collision Avoidance: Digital Master
Peer to Peer: Enabled
SID Repeat Range: 2-3
Modulation: E-Series Emulation Mode
Type: 9600 12.5KHz
Radio Type: Remote
Collision Avoidance: Digital
Ethernet SID: 250
Serial Rx SID: 3
Serial Tx SID: 2
Configuration
The configuration parameters shown in the diagram above can be accessed within the Q data radio within the following locations:
Modulation (Setup -> Radio -> Modulation) provides the compatibility options of: Q data Radio Mode or E-Series Emulation Mode.
Type (Setup -> Radio -> Modulation) provides the bandwidth/data rate options of:
- 9600 12.5KHz ACA 4 LeveL
- 19200 25KHz ACA 4 Level
These options may differ, depending on the region approval of the radio (ACMA/ETSI/FCC).
Radio Type (Setup -> Radio -> System Parameters) provides the options of:
- Access Point
- Remote