User's Manual

87
Document Number: 0100SM1401 Issue: 05-15
Router Mode
Point to Multipoint - Full Duplex Entry Point
Full Duplex Entry Point
Network Settings:
IP Address: 192.168.1.1/24
Router Settings:
WAN IP Address: 10.10.10.1/24
Route Table Entries:
192.168.2.0/24 10.10.10.2
192.168.3.0/24 10.10.10.3
Host Application
Network Settings:
IP Address: 192.168.1.10/24
Gateway: 192.168.1.1
Remote A
Network Settings:
IP: 192.168.2.1/24
Router Settings:
WAN IP Address: 10.10.10.2/24
Route Table Entries:
192.168.1.0/24 10.10.10.1
Remote B
Network Settings:
IP: 192.168.3.1/24
Router Settings:
WAN IP Address: 10.10.10.3/24
Route Table Entries:
192.168.1.0/24 10.10.10.1
Ethernet Device
IP: 192.168.2.2/24
Gateway: 192.168.2.1
Ethernet Device
IP: 192.168.3.2/24
Gateway: 192.168.3.1
Introduction
The following Diagrams are designed to provide configuration information on typical topologies. The channel bandwidth and
Tx/Rx frequencies are not shown within the diagrams, as they depend on the users license.
The following diagrams show ‘/24’ after an IP address. This short hand addressing indicates the device’s subnet mask. ‘/24’
equals a subnet mask of 255.255.255.0. Short hand addressing can be used when writing a static route.
Part G – Quick Start Guide
IP Route Configuration Example - Full Duplex Entry Point
In relation to the diagram above (Point to Multipoint - Full Duplex Entry Point) the following example shows how the IP Routing
configuration would appear within the Full Duplex Entry Point radio.
Each static route contains three parts: Network Address, Subnet Mask and Gateway.
The format of a static route can be either of the following: (Each yellow box shown requires a single space between them).
Network
Address
Subnet
Mask
Gateway
Network
Address
Subnet
Mask
Gateway