User's Manual
Table Of Contents
- Part A – Preface
- Safety Information
- Revision History
- Important Information
- Compliance Information
- Part B – Feature Overview
- Introduction
- Features and Benefits
- Q Data Radio Range
- Part C – System Topologies & Operating Modes
- System Topologies
- Operating Modes
- Part D – Feature Detail
- Hardware
- Efficiency and Bandwidth
- Connectivity
- Ease of Use
- Security
- Part E – Radio Planning and Design
- Radio Path analysis
- BER & Fade Margin
- Radio Accessories
- RF Feeders and Protection
- Part F – Quick Reference Guide
- Introduction
- Half Duplex Radio - QR450
- Full Duplex Radio - QB450
- Hot Standby Half Duplex Radio - QP450
- Hot Standby Full Duplex Radio - QH450
- LED indicators
- Connecting Antennas
- Communication Ports
- Activating Transmitter
- Factory Default
- Digital I/O
- Connecting to Web User Interface (WUI)
- Resolving Ethernet Connection Issues
- Part G– Quick Start Guide
- Step-by-Step Point to Point Setup
- Step-by-Step eDiags Setup
- System Topology Configuration
- Serial and MODBUS
- Single Frequency (Simplex) Mode
- E-Series Emulation Mode
- Part H – Advanced
- Connectivity
- Ease of Use
- Security
- Part I – Installation & Commissioning
- Optimising the Antenna for Rx Signal
- Commissioning
- Part J – Firmware Updating and Maintenance
- Firmware Updating
- Global Firmware Updating
- Fuse Replacement - QR450
- Part K – Open Source License Acknowledgements
- Part L – Support Options
59
Document Number: 0100SM1401 Issue: 05-15
Mounting Guidelines
The QP450 hot standby half duplex radio is housed as a 1RU 19” rack mounted unit. There are mounting brackets included
for the front panel, which can be used to secure the unit to the rack. The mounting brackets can be fitted to the side of each
unit in 3 different locations to provide different mounting capabilities: Front Mount, Proud Mount or Center Mount. Refer to
the QB450 Mounting guide for a graphical representation of the different mounting positions.
The unit should be mounted in a clean and dry location, protected from water, excessive dust, corrosive fumes, extremes of
temperature and direct sunlight. Allow sufficient passive or active ventilation to allow the radio fans to pass air through the
internal heat sink efficiently.
All RF, power and digital I/O connections are made at the rear of the unit. All User interfaces are located at the front of the
unit, this includes: Ethernet interface, Serial COM port interfaces and Auxiliary interface.
Physical Dimensions
19” (483mm) 1 RU rack mount.
Without mounting brackets, D:424 x H:44.45 x W:436.5mm (D:16.7” x H:1.75” x W:17.18”)
Part F – Quick Reference Guide