User's Manual
Table Of Contents
- Part A – Preface
- Safety Information
- Revision History
- Important Information
- Compliance Information
- Part B – Feature Overview
- Introduction
- Features and Benefits
- Q Data Radio Range
- Part C – System Topologies & Operating Modes
- System Topologies
- Operating Modes
- Part D – Feature Detail
- Hardware
- Efficiency and Bandwidth
- Connectivity
- Ease of Use
- Security
- Part E – Radio Planning and Design
- Radio Path analysis
- BER & Fade Margin
- Radio Accessories
- RF Feeders and Protection
- Part F – Quick Reference Guide
- Introduction
- Half Duplex Radio - QR450
- Full Duplex Radio - QB450
- Hot Standby Half Duplex Radio - QP450
- Hot Standby Full Duplex Radio - QH450
- LED indicators
- Connecting Antennas
- Communication Ports
- Activating Transmitter
- Factory Default
- Digital I/O
- Connecting to Web User Interface (WUI)
- Resolving Ethernet Connection Issues
- Part G– Quick Start Guide
- Step-by-Step Point to Point Setup
- Step-by-Step eDiags Setup
- System Topology Configuration
- Serial and MODBUS
- Single Frequency (Simplex) Mode
- E-Series Emulation Mode
- Part H – Advanced
- Connectivity
- Ease of Use
- Security
- Part I – Installation & Commissioning
- Optimising the Antenna for Rx Signal
- Commissioning
- Part J – Firmware Updating and Maintenance
- Firmware Updating
- Global Firmware Updating
- Fuse Replacement - QR450
- Part K – Open Source License Acknowledgements
- Part L – Support Options
50 Document Number: 0100SM1401 Issue: 05-15
DIN rail clip
The DIN rail clip has a spring loaded latch to allow easy installation/removal of the radio device being installed.
The DIN rail clip can be fitted to the DIN rail mounting bracket x5 different ways to allow as much installation flexibility as
possible.
Rear mount DIN rail clip
The DIN rail clip can be fitted on the rear of the DIN rail mounting bracket two ways shown below.
Examples of rear fitted DIN clips:
OR
68mm [2.68in.]
16mm [0.62in.]
[0.62in.]16mm
10mm [0.39in.]
5mm [0.19in.]
5mm [0.19in.]
44mm
[1.73in.]
[0.39in.]10mm
Part F – Quick Reference Guide