User's Manual
Table Of Contents
- Part A – Preface
- Safety Information
- Revision History
- Important Information
- Compliance Information
- Part B – Feature Overview
- Introduction
- Features and Benefits
- Q Data Radio Range
- Part C – System Topologies & Operating Modes
- System Topologies
- Operating Modes
- Part D – Feature Detail
- Hardware
- Efficiency and Bandwidth
- Connectivity
- Ease of Use
- Security
- Part E – Radio Planning and Design
- Radio Path analysis
- BER & Fade Margin
- Radio Accessories
- RF Feeders and Protection
- Part F – Quick Reference Guide
- Introduction
- Half Duplex Radio - QR450
- Full Duplex Radio - QB450
- Hot Standby Half Duplex Radio - QP450
- Hot Standby Full Duplex Radio - QH450
- LED indicators
- Connecting Antennas
- Communication Ports
- Activating Transmitter
- Factory Default
- Digital I/O
- Connecting to Web User Interface (WUI)
- Resolving Ethernet Connection Issues
- Part G– Quick Start Guide
- Step-by-Step Point to Point Setup
- Step-by-Step eDiags Setup
- System Topology Configuration
- Serial and MODBUS
- Single Frequency (Simplex) Mode
- E-Series Emulation Mode
- Part H – Advanced
- Connectivity
- Ease of Use
- Security
- Part I – Installation & Commissioning
- Optimising the Antenna for Rx Signal
- Commissioning
- Part J – Firmware Updating and Maintenance
- Firmware Updating
- Global Firmware Updating
- Fuse Replacement - QR450
- Part K – Open Source License Acknowledgements
- Part L – Support Options
48 Document Number: 0100SM1401 Issue: 05-15
DIN rail mounting kit
An optional DIN rail mounting kit is available for the QR450. The Mount is screwed onto the bottom of the QR450 giving the
unit the ability to be simply ‘clipped’ and Locked onto 7.5 mm by 35 mm (0.3 in. x 1.4 in.) DIN rail.
Each DIN rail kit supplies:
• A DIN rail mounting bracket
• A Phoenix DIN rail clip
• x4 Countersunk M4X8 screws (to mount DIN rail clip to bracket)
• x4 M4 nuts (to mount DIN rail clip to bracket)
• x4 Pan head M3X6 screws (to mount Spread spectrum radio to bracket)
• x4 Pan head M4X2.5 screws (to mount M-Series to bracket)
• x4 Pan head M4X8 screws (to mount QR450 to bracket)
Drawings not to scale.
118.5mm [4.66in.] (128.5mm [5.05in.] with DIN
clip fitted on rear)
12mm
[0.47in.]
2.5mm
[0.09in.]
48.5mm [1.9in.]
175mm
[6.89in.]
DIN rail mounting bracket
(58.5mm [2.3in.] with DIN
clip fitted on bottom)
Part F – Quick Reference Guide
2.5mm
[0.09in.]
12-24