User's Manual
Table Of Contents
- Part A – Preface
- Safety Information
- Revision History
- Important Information
- Compliance Information
- Part B – Feature Overview
- Introduction
- Features and Benefits
- Q Data Radio Range
- Part C – System Topologies & Operating Modes
- System Topologies
- Operating Modes
- Part D – Feature Detail
- Hardware
- Efficiency and Bandwidth
- Connectivity
- Ease of Use
- Security
- Part E – Radio Planning and Design
- Radio Path analysis
- BER & Fade Margin
- Radio Accessories
- RF Feeders and Protection
- Part F – Quick Reference Guide
- Introduction
- Half Duplex Radio - QR450
- Full Duplex Radio - QB450
- Hot Standby Half Duplex Radio - QP450
- Hot Standby Full Duplex Radio - QH450
- LED indicators
- Connecting Antennas
- Communication Ports
- Activating Transmitter
- Factory Default
- Digital I/O
- Connecting to Web User Interface (WUI)
- Resolving Ethernet Connection Issues
- Part G– Quick Start Guide
- Step-by-Step Point to Point Setup
- Step-by-Step eDiags Setup
- System Topology Configuration
- Serial and MODBUS
- Single Frequency (Simplex) Mode
- E-Series Emulation Mode
- Part H – Advanced
- Connectivity
- Ease of Use
- Security
- Part I – Installation & Commissioning
- Optimising the Antenna for Rx Signal
- Commissioning
- Part J – Firmware Updating and Maintenance
- Firmware Updating
- Global Firmware Updating
- Fuse Replacement - QR450
- Part K – Open Source License Acknowledgements
- Part L – Support Options
34 Document Number: 0100SM1401 Issue: 05-15
Web User Interface (WUI)
Q data radios provide a graphical Web User Interface (WUI) which can be accessed by a web browser to perform
configuration changes. This helps to eliminate the requirement for stand-alone configuration software to be installed on a PC.
Text User Interface (TUI)
The text user interface (TUI) provides an alternative to the HTML web user interface for configuration and diagnostics. The
TUI can be accessed directly from the serial port of the Q data radio or via a telnet or SSH session. The TUI is enabled on
COM 1 by default, while Telnet is also enabled by default, however, this requires an Ethernet connection. Access to the TUI
via the serial port is useful if you have forgotten the IP address of the radio you are trying to configure or diagnose.
Part D – Feature Detail