User's Manual
Table Of Contents
- Part A – Preface
- Safety Information
- Revision History
- Important Information
- Compliance Information
- Part B – Feature Overview
- Introduction
- Features and Benefits
- Q Data Radio Range
- Part C – System Topologies & Operating Modes
- System Topologies
- Operating Modes
- Part D – Feature Detail
- Hardware
- Efficiency and Bandwidth
- Connectivity
- Ease of Use
- Security
- Part E – Radio Planning and Design
- Radio Path analysis
- BER & Fade Margin
- Radio Accessories
- RF Feeders and Protection
- Part F – Quick Reference Guide
- Introduction
- Half Duplex Radio - QR450
- Full Duplex Radio - QB450
- Hot Standby Half Duplex Radio - QP450
- Hot Standby Full Duplex Radio - QH450
- LED indicators
- Connecting Antennas
- Communication Ports
- Activating Transmitter
- Factory Default
- Digital I/O
- Connecting to Web User Interface (WUI)
- Resolving Ethernet Connection Issues
- Part G– Quick Start Guide
- Step-by-Step Point to Point Setup
- Step-by-Step eDiags Setup
- System Topology Configuration
- Serial and MODBUS
- Single Frequency (Simplex) Mode
- E-Series Emulation Mode
- Part H – Advanced
- Connectivity
- Ease of Use
- Security
- Part I – Installation & Commissioning
- Optimising the Antenna for Rx Signal
- Commissioning
- Part J – Firmware Updating and Maintenance
- Firmware Updating
- Global Firmware Updating
- Fuse Replacement - QR450
- Part K – Open Source License Acknowledgements
- Part L – Support Options
118 Document Number: 0100SM1401 Issue: 05-15
Summary of SNMP MIB Objects Supported
Object name Object Identifier (OID) Syntax Object description
General Group:
serialNumber .1.3.6.1.4.1.33302.30.1.1.0 String Serial number of the Q data radio
modelNumber .1.3.6.1.4.1.33302.30.1.2.0 String Model number of the Q data radio
hardwareRevision .1.3.6.1.4.1.33302.30.1.3.0 String Hardware revision of the Q data radio
firmwareRevision .1.3.6.1.4.1.33302.30.1.5.0 String The firmware revision the Q data radio
date .1.3.6.1.4.1.33302.30.1.6.0 String The date as reported by the Q data radio
time .1.3.6.1.4.1.33302.30.1.7.0 String The time as reported by the Q data radio
utcTimeOffset .1.3.6.1.4.1.33302.30.1.8.0 String Time offset from UTC for the Q data radio’s
local time zone
upTime .1.3.6.1.4.1.33302.30.1.9.0 String The uptime of the Q data radio
primaryNtpServer .1.3.6.1.4.1.33302.30.1.10.0 String Primary Network Time Protocol (NTP) domain
name
cpuLoad .1.3.6.1.4.1.33302.30.1.11.0 Integer Average CPU utilisation (%) for the past 15
minutes
supplyVoltage .1.3.6.1.4.1.33302.30.1.12.0 Integer Supply Voltage of the Q data radio in mV
temperatureC .1.3.6.1.4.1.33302.30.1.13.1.3.1 Integer The internal temperature of the Q data radio
(degrees C)
temperatureF .1.3.6.1.4.1.33302.30.1.13.1.4.1 Integer The internal temperature of the Q data radio
(degrees F)
ipAddress .1.3.6.1.4.1.33302.30.1.15.0 String The IP address of the Q data radio.
Radio Group:
radioReceivedPackets .1.3.6.1.4.1.33302.30.2.3.0 Integer Number of packets received from over the
radio link
radioTrasnmittedPackets .1.3.6.1.4.1.33302.30.2.4.0 Integer Number of packets transmitted over the radio
link
radioForwardPower .1.3.6.1.4.1.33302.30.2.5.1.2.1 Integer Level of transmit power (dBm)
radioReversePower .1.3.6.1.4.1.33302.30.2.6.1.2.1 Integer Level of reverse power (dBm)
radioVswr .1.3.6.1.4.1.33302.30.2.7.1.2.1 Integer VSWR
radioRssiValue .1.3.6.1.4.1.33302.30.2.8.1.2.1 Integer Radio RSSI value (dBm)
radioDataRate .1.3.6.1.4.1.33302.30.2.15.0 Integer The over-the-air data rate of the Q data radio.
[Dynamic(0), 8000bps(1), 14000bps(2),
16000bps(3), 24000bps(4), 28000bps(5),
32000bps(6), 42000bps(7), 56000bps(8)]
txFrequency .1.3.6.1.4.1.33302.30.2.18.0 Integer Radio’s transmit frequency (Hz).
rxFrequency .1.3.6.1.4.1.33302.30.2.19.0 Integer Radio’s receive frequency (Hz).
muteThreshold .1.3.6.1.4.1.33302.30.2.20.0 Integer Radio’s mute threshold (dBm).
rxGoodFrameCount .1.3.6.1.4.1.33302.30.2.23.0 Integer Good frames received.
rxGoodByteCount .1.3.6.1.4.1.33302.30.2.24.0 Integer Good bytes received.
rxBadFrameCount .1.3.6.1.4.1.33302.30.2.25.0 Integer Bad frames received.
rxAverageGoodFrameSize .1.3.6.1.4.1.33302.30.2.26.0 Integer Average received good frame size.
rxAverageFrameRate .1.3.6.1.4.1.33302.30.2.27.0 Integer Average receive frame rate.
rxChannelOccupancy .1.3.6.1.4.1.33302.30.2.28.0 Integer Receive channel occupancy.
rxSlidingChannelOccupancy .1.3.6.1.4.1.33302.30.2.29.0 Integer Sliding channel occupancy.
txByteCount .1.3.6.1.4.1.33302.30.2.31.0 Integer Transmitted byte counter.
txFrameCount .1.3.6.1.4.1.33302.30.2.32.0 Integer Transmit frame count.
txAverageFrameSize .1.3.6.1.4.1.33302.30.2.33.0 Integer Transmit average frame size.
txAverageFrameRate .1.3.6.1.4.1.33302.30.2.34.0 Integer Transmit average frame rate.
radioFrequencyError .1.3.6.1.4.1.33302.30.2.36.0 Integer Radio frequency error (Hz).
Part H – Advanced