User's Manual
Table Of Contents
- Part A – Preface
- Safety Information
- Revision History
- Important Information
- Compliance Information
- Part B – Feature Overview
- Introduction
- Features and Benefits
- Q Data Radio Range
- Part C – System Topologies & Operating Modes
- System Topologies
- Operating Modes
- Part D – Feature Detail
- Hardware
- Efficiency and Bandwidth
- Connectivity
- Ease of Use
- Security
- Part E – Radio Planning and Design
- Radio Path analysis
- BER & Fade Margin
- Radio Accessories
- RF Feeders and Protection
- Part F – Quick Reference Guide
- Introduction
- Half Duplex Radio - QR450
- Full Duplex Radio - QB450
- Hot Standby Half Duplex Radio - QP450
- Hot Standby Full Duplex Radio - QH450
- LED indicators
- Connecting Antennas
- Communication Ports
- Activating Transmitter
- Factory Default
- Digital I/O
- Connecting to Web User Interface (WUI)
- Resolving Ethernet Connection Issues
- Part G– Quick Start Guide
- Step-by-Step Point to Point Setup
- Step-by-Step eDiags Setup
- System Topology Configuration
- Serial and MODBUS
- Single Frequency (Simplex) Mode
- E-Series Emulation Mode
- Part H – Advanced
- Connectivity
- Ease of Use
- Security
- Part I – Installation & Commissioning
- Optimising the Antenna for Rx Signal
- Commissioning
- Part J – Firmware Updating and Maintenance
- Firmware Updating
- Global Firmware Updating
- Fuse Replacement - QR450
- Part K – Open Source License Acknowledgements
- Part L – Support Options
115
Document Number: 0100SM1401 Issue: 05-15
SNMP Notifications
Configure basestation specific features to send SNMP notifications when a respective event occurs.
GPIO Inputs - By enabling SNMP notification on a GPIO input, the radio will send an SNMP notification to the NMS specified in
the configured SNMP section (to access SNMP, go to: Setup -> SNMP), when the respective digital input state changes.
Advanced
Periodic Switch Over Period - The period, in hours, after which the online base station will initiate an automatic switch over.
This can be useful, to exercise each radio within a hot standby arrangement, to validate redundant link availability.
Setting a value of zero will disable this feature.
Base Station Health - By enabling the Base Station Health SNMP notification, the radio will send an SNMP notification to the
NMS specified in the configured SNMP section (to access SNMP, go to: Setup -> SNMP), when a change in alarm state for the
base health alarm occurs.
Base change over - By enabling the Base change over SNMP notification, the radio will send an SNMP notification to the NMS
specified in the configured SNMP section (to access SNMP, go to: Setup -> SNMP), when a hot standby base change over
occurs.
Part H – Advanced