User's Manual

Document Number: 0100SM1401 Issue: 10-14

Connecting Antennas

The RF antenna system should be installed in accordance with the manufacturer’s instructions and local regulatory

requirements.

•The RF (Antenna) connector on the QR450 is a TNC type female connector.

•The RF (Antenna) connectors on the QB450 and the QP450 are N-Type female connectors.

Good quality, low loss, feeder cable, should be considered according to the length of the cable run. also, use a short, flexible

patch cable between the radio and lightning arrestor or flange mount of the radio cabinet/enclosure. Ensure all external

connections are waterproofed.

Communication Ports

Ethernet Ports (ETH)

The ETH ports are 10/100 Base-T compliant, using RJ-45 sockets. These sockets support both TIA/EIA-568-A & B wiring as

they have Auto MDI/MDIX Auto Sensing. This means you can use both straight-through and cross-over type CAT-5 or better

patch cables. All RJ45 connectors should utilize mating plugs that include an integral locking tab.

Note: If termination of a cable is required, then the

following wiring arrangement should be followed

(Compliant with TIA/EIA-568-A).

Note: Maximum differential voltage : 5v, 50mA max

through each differential pair.

Note: If 100-BaseT connection speed is required, CAT-6

Shielded cable should be used for installation to comply

with ETSI EMC directives.

QB450 & QP450 QR450

Part F – Quick Reference Guide