User's Manual
Table Of Contents
- Part G – Mounting and LED Indicators
- Mounting & Connector Information
- Antenna Port Cabling (Hazardous Installations)
- Product Labelling
- LED Indicators
- Part H – Programming and Diagnostics
- Programming
- Diagnostics
- Part I – K Series PCB Overlay & Schematics
- Schematics
- Overlay
- Part I – Specifications
- Appendix – FCC Approved Antennas
Page 20
© Copyright 2008 Trio DataCom Pty. Ltd.
O Series Data Radio – User Manual
Part H – Programming and Diagnostics
Programming
The O Series OEM module is programmed via the System Port.
There are two methods of programming:
(a) In Situ : Programming via the 3-wire System Port pins
(b) In K-Series : OEM Module can be plugged into a K Series
carrier PCB and programmed via the System Port on the K
Series.
The O Series OEM module is programmed using the TVIEW+
Management Suite : K Series programmer.
Programming of the O Series is similar to the K Series - however
some features are optional on the O-Series (dependent on external
support circuitry). The features that require external support
circuitry which may or may not be relavent to your design are:
(a) RS-485 .
(b) Multi-master Synchronisation.
(c) RSSI Output
(d) Port B
(a) Port A & B Hardware handshaking signals
For a comprehensive guide to programming the O Series OEM
module, please refer to the TVIEW+ K Series User Manual - Part
G.
Diagnostics
The O Series OEM module includes diagnostics which is useful for
fault fi nding and system commisioning. Detailed information about
O Series diagnostics is available in the TVIEW+ Diagnostics User
Manual.
TVIEW+ Diagnostics is available via the System Port of the O
Series module. To access the diagnostics facilities locally, the
System Port of the O Series must be brought out to a connector for
connecion to the computer running the diagnostics package.
Alternatively, remote diagnostics connectivity is available “over-the-
air”. More information on confi guring diagnostics can be found in
both the TVIEW+ Diagnostics User Manual and the K Series User
Manual.
The OEM user may also wish to integrate O Series diagnostics
into their own application. To facilitate this, Trio Datacom can
provide the specifi cations document for the “Remote Diagnostics
Protocol”. This document specifi es how diagnostics messages
are constructed and what facilities are available. To obtain this
document, please contact the factory on support@triodatacom.
com.